Check out our list of 7 reasons why your rotator cuffs might be mad at you and rotator training tips to make sure you keep these in mind for all of your clients so they're never leaving a workout injure or in pain!

7 Ways Your Workout is Hurting Your Rotator Cuffs


The shoulder joint (and its connective muscles, tendons, and ligaments) have a greater range of motion than all other joints in the human body, which provides a very wide array of movement.

The group of muscles and connections that combine to facilitate this movement are called the rotator cuff. 

However, the extremely complex anatomical structure that provides so much flexibility in movement patterns also unfortunately make the shoulder joint quite susceptible to injury, especially to those who spend a lot of time in the gym pushing and pulling heavy iron.

So if your shoulders or your client's shoulders are constantly in pain, there is a good chance there's an irritated and inflamed joint that needs some TLC.

Check out our list of 7 reasons why your rotator cuffs might be mad at you and make sure you keep these in mind for all of your clients so they're never leaving a workout injure or in pain!


Insufficient Warm-Up

 This may be the most common cause of rotator cuff issues, as the majority of trainers out there fail to take the proper time to warm-up the shoulders before even beginning the first upper body movement.

Esteemed Coach Eric Broser highly recommends everybody put together a basic series of callisthenic-type exercises (such as arm windmills, shoulder rolls, etc.) to begin each workout, followed by high rep sets of rear, front and side laterals, as well as overhead presses. Then, when you get to your first true exercise, make sure to perform several progressively heavier warm-up sets to prepare the joint for the exact movement pattern it will soon be engaged in under high loads.


Faulty Use of Behind the Neck Exercises 

Behind the Neck Pull downs and Presses have certainly been responsible for many an injured rotator cuff.

However, for a healthy shoulder joint, neither of these two exercises are inherently “evil.” The problems lie in too exaggerated range of motion, improper technique, and/or use of too much weight (where the joint is in a somewhat “compromised” position this can be rather hazardous).

Coach Eric Broser suggests never allowing the bar on pull downs or presses to go below the level of the bottom of the ears to keep from overstretching the attachments. Also, make sure to move the weight extra slowly, such as 2-3 second positives and negatives, to keep the tension on the muscle and off the joint. Finally, Eric believes it is best to perform no less than about 8-10 reps on behind the neck exercises.


Improper Use of Upright Rows

This is another exercise that can also be hard on the rotators, but in a different way than those above. The problem here is when one performs this movement with too close a grip and/or lifts the bar too high at the point of peak contraction.

This can cause impingement at the joint, which can result in pain and irritation of the rotator cuff tendons, and eventually a chronic condition. Try utilizing a shoulder width grip on the bar and that you pull it no higher than the point where the elbows are in line with the shoulders.


Overuse Abuse

“Overuse injuries” occur in the weight room when the same exercises are used too often in a training program, with the rotator cuffs being highly susceptible to this type of issue.

Unfortunately when we force our bodies to use the same movement pattern over and over it causes micro trauma in the surrounding tendons, bones and joints, eventually leading to injury.

This can easily be avoided by constantly switching in and out of your workouts somewhat different exercises on a rotating basis.


In the spirit of providing you with the best partnerships around we've teamed up with elite personal trainer Eric Broser. Eric has more than 30 years of experience personal training and can get you beach bod ready in no time.

IFG has scored you an exclusive 10% OFF all of his training services. Click the image to email him and learn more!


Poor Exercise Technique

Let’s face itmost injuries of all kinds occur in the gym because of poor lifting form and technique.

Using momentum and swinging and/or uncontrolled rep speeds can wreak havoc on the lower back, neck, knees, hips, wrists, elbows, and without a doubt, the rotator cuffs. Keep your ego or your client's ego  in check and try to always move the weights from point A to B under full control, and by using only the intended target muscles.


Too Frequent Use of Heavy/Low Rep Workouts

While heavy, lower-rep, training is both satisfying and effective, it is not the best way to go about making continuous progress in muscle growth.

In addition, forcing the rotator cuffs to constantly deal with extremely heavy poundage is not the best way to keep your shoulder joints healthy and pain free!

You must remember that the rotator cuffs are not “built” for heavy pounding like the main deltoid muscles, so you must take care to rotate your training between periods of low, medium and high reps in order to allow proper recovery to take place.


Neglecting to Directly Train the Rotators

 Very few people  in the gym perform exercises that directly work the various rotator cuff muscles. This is not a great approach to pain-free lifting because it will eventually create a strength imbalance between the upper body muscle groups, which in time will force the rotators to withstand loads they are not prepared for.

If you add 100 lbs. to your bench press you better also make sure your rotator cuffs are also getting as proportionately strong as your delts, tris and pecs!

Learn about the various internal and external rotation exercises and add them into your routine.

For more training tips, check out Coach Eric Broser.
set A training session with him to improve your own gym routine or to improve your training techniques for your clients!
ADD COMMENT